-
Cant Get Shunt to Show 100%
Been using 500 Amp shunts for 2 years and they work as they should and i think i have a reasonably good understanding however for some reason i cant get my New Lithium to show 100% , will go to 98.8 ish but that’s it , goes into Float and hovers around there for hours with current going in to match loads and capacity still hovering around 98% . As far as i am aware settings are all correct , i have tried synchronizing to 100% but then next day its repeats and just wont get to full again . Tried changing battery voltage to 28.8 also . Voltage . I dont have the same problem with my AGMs .
-
0 Replies
Sorry, there were no replies found.
Log in to reply.